Tarp Floor And How To Stake Tight

Stake down one side of the tarp.

Tarp floor and how to stake tight.

Stake out the back corners and back wall guy lines. Tie a length of cord between the tent stake and the corner of the tarp. You will also need to tie off some drip lines above the entrance of the shelter to prevent rain from running down the paracord and into the shelter. Then stake down and tension the pole s guyline at about a 90 angle from that side of the tarp.

The length and angle of the trekking pole. The tarp should be about 6 8 inches 15 cm off the ground all the way around. The tarp is draped over the paracord diagonally while the leading edges fold under to form the floor. The 30 degree angle of the tarp s roof will create a ten foot long living area.

Hammer in the stakes on each corner making sure it is tightly secured. The corner of the shelter must be faced towards the direction of the wind. Here s how to set up your tarp shelter as a wind shed. The distance apart of the two front corner stakes when you first lay out the tarp.

The a frame shelter is probably the most common shelter one can make. Throw the tarp over the line so the middle of the tarp meets the cord. Put a trekking pole angled slightly in the middle of an adjacent side of the tarp. It can be made by stringing the paracord between two trees.

Make sure the line is tight to prevent any sagging. If you have trouble getting a good pitch try playing around with the following. Make sure this cord is tight and holds the tarp securely to the ground. Draping over the tarp and staking it down are the final steps required to make this standard shelter.