The float switch through at least two complete cycles.
Tethered float switch adjustment.
The pump is then idle until the water level rises again.
Tether length.
Rod settings are made by sliding the sump float up and down the desired.
Manual adjustment manual adjustments are made on either a rod or a tether depending upon the model of sump pump you own.
When the float rises to a pre set height the pump will be switched on.
Step by step disconnect from power.
Adjust float up or down.
Efore tightening adjust tether length.
Make any necessary adjustments at this time.
The pump will continue to operate until the float drops low enough to disengage the switch.
Next manually or electronically adjust the float switch up or down based on the water level in.
The float controls an on off switch for the pump.
To order a pump for your diy grey water project email sales greywaterdiy co za south africa or click here to order from amazon.
Anytime you are working on your sump pump it should be disconnected from the power.
Pump sold separately.